TRAXXAS Slash Rear CVD Shafts Aluminium 6061-T6 with 304 Stainless - SSLA1277RHA by GPM  [SSLA1277RHA]

Replacement rear CVD assembly for TRAXXAS Slash

This aftermarket rear CVD drive shaft set fits TRAXXAS Slash chassis and is engineered for 1/10 scale drivetrains. Stainless steel 304 is used for the joint components while the shaft barrels are machined from aluminium 6061-T6 to keep weight down and resist corrosion.

Key features focus on protecting the drivetrain. The joint area is shielded by the axle design to limit contact with rocks and muck. Shore-stable silicone O-rings at the coupling point help absorb impact shock, and the anodised 6061-T6 bodies are produced with a slightly beefed-up wall thickness for improved wear life without altering fitment dimensions.

Installation advice: the parts are intended for rear gearbox-to-wheel fitment on the compatible Slash models listed below. The pack includes optional 3mm steel hex shims to fine tune wheel hex engagement. Inspect hex spacing and follow the original manufacturer torque specs when installing. Designed for RC 1/10 applications only.

Use this kit if you need enhanced joint protection and thicker shaft walls for longer service intervals; confirm wheel hex and gearbox clearance before fitting to your Slash.