Traxxas Summit Steering Mount Alloy Holder SUM050 by GPM  [SUM050]

Aluminium steering holder for Summit rigs

The SUM050 steering holder is supplied as 1 pcs and serves as an alloy replacement for the standard steering mount on Traxxas Summit models. It reduces chassis-side flex and gives a firmer pivot point where the steering linkage mounts to the chassis.

As a direct-fit aftermarket component for Summit-series applications mentioned in the title, this holder is intended as a scale upgrade to the original mounting part. Fitment normally requires removal of the old holder, transfer of any original fixings or spacers, and careful alignment of the servo horn and steering linkage to confirm full travel without interference.

From a setup perspective, moving to an alloy holder increases the stiffness of the steering assembly rather than changing steering geometry; this typically delivers more consistent steering feedback under load, which assists with precise crawling and trail performance. Always verify clearances and re-check screw torque after installation.