TRAXXAS Tmaxx 3.3/1.1 Output Bearing Clamp Alloy TMX1011A by GPM  [TMX1011A]

Alloy clamp for Tmaxx gearbox output

This aftermarket alloy output bearing clamp is made for TRAXXAS Tmaxx platforms and carries the identifier TMX1011A. As an RC gearbox accessory it mounts at the output bearing location on the Tmaxx 3.3 and Tmaxx 1.1 gearcases and is sold as 1pc.

The primary role of the clamp is to secure the output bearing, holding axial position and cutting down play between the gearbox output and the driveline. Alloy material helps avoid bending or distortion during typical RC use, supporting repeatable alignment when replacing the original plastic piece.

Fitting is a simple task for anyone used to gearbox service: remove the case cover, replace the old clamp with this alloy unit and refasten using the original screws. Confirm free bearing rotation and recheck fitment in a short bench test before full running.