TRAXXAS T-Maxx Centre Driveline Alloy Gearbox TMX1038 for 1/10 by GPM  [TMX1038]

TRAXXAS 1/10 T-Maxx Monster Truck (Options) Alloy Centre Gear Box With Screws & Collars- 1set - GPM TMX1038
Price:
NZD$169.68
Brand:
GPM
Model:
TMX1038
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Reinforced alloy centre gearbox for scale T-Maxx

The TMX1038 alloy centre gear box is an aftermarket replacement built for TRAXXAS 1/10 T-Maxx vehicles and comes as a single set including the required screws and collars. It replaces the stock plastic centre gearbox to provide a tougher, longer-lasting centre driveline component while keeping chassis geometry unchanged.

Made for scale RC use, this part aims to increase service life in the centre driveline assembly. Fitting involves basic disassembly of the centre differential and driveline housings, and it aligns with standard T-Maxx centre gear layouts on typical 1/10 platforms.

Specifications

  • Item Alloy centre gear box with screws and collars
  • Material Alloy
  • Model Number TMX1038
  • Compatibility TRAXXAS 1/10 T-Maxx

Fit this alloy centre gear box to lower flex and slow wear in the centre driveline; confirm fit with your diff housings before tightening, and use light grease on bearings and gear meshes for consistent performance.

Does the TMX1038 include fasteners?

Yes, the package includes the alloy centre gearbox plus the mounting screws and collars needed to secure it.

Will it change ride handling?

The alloy housing increases stiffness which can slightly change driveline feel, but the part is primarily intended for durability rather than tuning handling characteristics.

What should I check during install?

Verify mounting hole alignment, seal contact faces and gear mesh during a dry trial fit before final assembly and torqueing of fasteners.

Is this compatible with tuned drivelines?

It is compatible with standard T-Maxx centre gear arrangements; if you run nonstandard diffs or modified housings, double-check clearances first.

Recommended lubrication?

Use a light grease on bearings and gear contact surfaces and inspect periodically to prevent abrasive wear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved