TRAXXAS Tmaxx Rear Bulk Head Side Plates TMX1013 Upgrade by GPM  [TMX1013]

Aluminium rear bulk head side plate set for Tmaxx

This alloy rear bulk head side plate set is intended for TRAXXAS Tmaxx vehicles and is listed under model TMX1013. It replaces the original plastic side pieces and comes with the screws, pins, collars, lock nuts and E-clips noted in the product title to reduce fitment fuss.

Machined from aluminum alloy, the plates add structural rigidity over stock components while remaining appropriate for routine off-road use and bashing. They function as a chassis stiffening and tuning upgrade rather than as a standalone drivetrain part.

Fitting notes and tuning guidance:

• Compatibility: built for TRAXXAS Tmaxx 3.3 and Tmaxx 1.1 chassis variants; verify your rear bulk head layout first.
• Fitment: designed as direct-replacement side plates using the supplied hardware; remove the rear bulk head assembly and swap the panels following normal service practice.
• Tuning impact: alloy side plates tend to firm the rear, improving stability and steering precision but reducing some suspension compliance on very rough tracks.
• Maintenance: inspect fastener torque and E-clip seating after initial runs and after heat cycles to prevent loosening.

A practical aftermarket replacement for damaged or flexible stock parts, this alloy rear bulk head side plate set gives a reliable way to increase rear stiffness on Tmaxx 3.3 and 1.1 rigs while including the hardware needed for installation.