TRAXXAS T-Maxx Servo Mount Alloy with 4mm Steel Handle STMX2112 by GPM  [STMX2112]

This aftermarket alloy servo mount and 4mm steel arm are supplied as a direct-replacement set for TRAXXAS 1/10 T-Maxx models. The design focuses on increasing stiffness where the servo attaches to the chassis to resist flex during high-impact off-road use.

Replacing the factory plastic bracket with the alloy mount reduces deflection at the mounting points, which helps keep steering inputs consistent when fitting higher torque servos or tuning for aggressive jump and cornering behaviour. The 4mm steel arm gives a stronger link from servo output to the steering linkage for crisper steering on rough tracks.

Fitment tips: intended as an accessory for TRAXXAS T-Maxx 1/10 variants; reuse the original fasteners where they match, and confirm servo spline engagement and hole alignment before tightening. A small amount of shimming may be needed on earlier or customised chassis to obtain a flush installation. Use thread locker on metal-to-metal threads for secure assembly.

Tuning advice: install the alloy mount to cut down movement at the servo anchor, then recheck steering travel and subtrim to suit the changed leverage. This part supports mechanical setup and should be used alongside proper suspension and electronics tuning.