TRAXXAS T-Maxx Steering and Suspension Ball Ends TMX13100A+B/BE by GPM  [TMX13100A+B/BE]

Aftermarket ball end set for linkages

This set contains plastic ball ends and matching balls designed for TRAXXAS 1/10 T-Maxx TMX13100A and TMX13100B applications. Sold as 1 pr, these items are intended as aftermarket replacements where original ball ends show wear or damage.

The components are molded plastic selected to give a practical balance between economy and service life for general trail and bash conditions on 1/10 monster trucks. Installation is straightforward: detach the old ball end from the linkage stud and press the replacement ball into the socket until it clicks into place. After fitting, check articulation and take up any slack by adjusting link length if needed.

These ball ends are handy for maintenance and setup work, acting as replaceable pivots in steering and suspension linkages when restoring correct geometry after impacts or when replacing worn stock parts. They are specifically compatible with TMX13100A and TMX13100B fittings and designed for RC use only.