Traxxas TRX-4 Aluminum Rear Damper Tower Brackets JR-TRX414-B by Jazrider  [JR-TRX414-BK]

Traxxas TRX-4 Aluminum Rear Shock Tower Damper Mount Set (Black)
Price:
NZD$19.79
Brand:
JAZRIDER
Model:
JR-TRX414-BK
Condition:
Brand New
Write a review

Rear Tower Shock Damper Bracket

This black-anodized aluminum rear shock tower damper mount set is designed specifically for Traxxas TRX-4 chassis, providing a robust aftermarket option for the rear damper attachment points while keeping a scale appearance.

The brackets mount at the TRX-4 rear tower locations, supporting damper linkages and allowing modest adjustment of shock angle and clearance to suit different setups. Always confirm fit on your specific model before final assembly.

To install, line up the bracket with the rear tower holes and secure with the vehicle's existing hardware where suitable. Inspect shock travel and clearance after installation and re-tighten fasteners after initial running to verify secure fitment.

Do I need additional screws or washers to fit these?

In most cases the chassis' existing fasteners will work, but check thread size and length for your TRX-4 variant and have suitable replacements on hand if needed.

Any tips for aligning the mounts correctly?

Seat the mount fully against the tower face, start screws by hand to avoid cross-threading, then tighten evenly to maintain alignment across both sides.

Should I check clearance before final tightening?

Yes. Cycle the suspension to confirm there is no interference with links or the body and re-check fastener torque after a short test run.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved