Traxxas TRX-4 Aluminum T-Lock Servo Mount Upgrade - JR-TRX404-BK by Jazrider  [JR-TRX404-BK]

Traxxas TRX-4 Aluminum T-Lock 2-Speed Servo Mount (Black)
Price:
NZD$21.52
Brand:
JAZRIDER
Model:
JR-TRX404-BK
Condition:
Brand New
Write a review

Overview and Fitment for TRX-4

The JR-TRX404-BK is an aluminum T-Lock 2-speed servo mount built for Traxxas TRX-4 chassis. Supplied in black, it is aimed at scale and trail crawler builds that need a compact metal mount to secure T-Lock or 2-speed servo setups while keeping clearance low and strength high.

Fitting typically replaces the stock plastic footprint with this aluminum unit, lining it up with the TRX-4 servo bay and fastening with the vehicle's original chassis screws where possible. Always re-check linkage geometry and horn clearance during the final adjustment stage.

From a durability standpoint JR-TRX404-BK gives a firmer mounting surface to limit flex under torque, which can stabilise actuation for lockable transfer cases and when running beefier servos. Consider it a rugged, scale-focused hop-up rather than a way to change servo sizing.

How tough is the aluminum used here?

The mount is machined from aluminum to give a solid mating surface that resists flex and wear better than the stock plastic parts typically used on TRX-4 models.

Will it corrode in wet conditions?

The black finish provides basic surface protection but treat exposed threads and mating surfaces appropriately if running the model in salty or highly humid environments.

Does the JR-TRX404-BK require specific fasteners?

It is designed to use the TRX-4 chassis screw pattern; however, verify thread size and length before tightening and replace with correct hardware if needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved