TRAXXAS TRX4 Front Brushguard Adjustable Aluminium Trail Bumper - TRX4330FE by GPM  [TRX4330FE]

Adjustable Aluminium Front Guard for Trail Use

The TRX4330FE aluminium front brushguard is an aftermarket upgrade aimed at scale trail and crawler builds, featuring adjustable height and approach angle so you can tweak ground clearance for technical sections. It is laid out to accept a winch and auxiliary lights while keeping carried weight low to avoid upsetting suspension balance.

This is a 7 piece assembly supplied with mounting screws and two D-rings ready for fast installation. Fabricated from aircraft-grade 6061-T6 aluminium, the bumper blends strength with reasonable mass. The central rail spacing is selectable between 42 and 44mm to suit a range of mounting patterns, and the winch mount matches RC4WD single motor winch hole pattern Z-S1571 with a maximum fit width of 74mm; anything wider will not mount.

Fitment advice: the unit uses existing chassis mounting points where possible, and approach angle and height are set using the included hardware. The open front area leaves room for lighting kits. Always check winch mount dimensions before ordering and retain the stainless steel fasteners supplied.

Designed for scale protection and accessory mounting, this bumper gives adjustable clearance options to suit different trail setups and the platforms listed in the compatibility box.