Traxxas TRX-4 Gearbox Skid Plate Upgrade for Axles - JR-TRX440 by Jazrider  [JR-TRX440]

Traxxas TRX-4 Stainless Steel Front/Rear Axle Gear Box Bottom Protector Guard
Price:
NZD$10.57
Brand:
JAZRIDER
Model:
JR-TRX440
Condition:
Brand New
Available in shop
Write a review

Skid Plate Protection for TRX-4 Axles

This skid-style bottom protector is built for the Traxxas TRX-4 to cover the lower surfaces of the front and rear axle gearboxes during trail use and scale crawling. The stainless construction resists abrasion and rock strikes while avoiding any claim of drivetrain performance enhancement.

Designed to mount under the axle housings, this part aligns with TRX-4 factory mounting points; always verify fitment on your specific axle build to ensure there is no contact with suspension articulation or driveline components.

Use the skid plate when tackling rocky trails, ledges, or debris-strewn runs to reduce wear to the gearbox underside; it is sold as a protective aftermarket accessory for scale and trail vehicle setups.

How tough is the stainless guard against rocks?

Stainless steel offers good abrasion and impact resistance for underside protection, but no metal is indestructible; avoid severe impacts and inspect the guard after heavy impacts for deformation.

Will this prevent gearbox damage in all situations?

The protector reduces direct contact and abrasion to the gearbox underside but cannot guarantee protection against extreme impacts or chassis failures; it is an added layer of defense for typical trail conditions.

Is any finishing required after installation?

Minimal finishing may be needed; ensure fasteners are secure and check that edges do not rub against suspension boots or drive components during full articulation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved