JAZRIDER JR-TRX417-10MM Brass 12mm Hex Hub Kit 10mm Thick  [JR-TRX417-10MM]

Traxxas TRX-4 HD Brass 12mm Wheel Hex Hubs Adapter (10mm thick)
Price:
NZD$12.09
Brand:
JAZRIDER
Model:
JR-TRX417-10MM
Condition:
Brand New
Write a review

Upgraded Brass Hex Hubs for Traxxas TRX-4

The JAZRIDER JR-TRX417-10MM brass wheel hex hubs are intended to refine your Traxxas TRX-4 handling on rough terrain. These 12mm hex adapters feature a solid 10mm thickness to add ballast at the wheel, helping the crawler track straighter and stick better on uneven surfaces. Ideal for modelers wanting a straightforward stability upgrade.

Why Fit Brass Hubs?

Brass is prized for durability and useful mass, both of which help lower the centre of gravity and stabilise wheel motion during climbs. The hubs are accurately machined to mate with TRX-4 wheel fittings, ensuring consistent wheel alignment and reliable on-rail performance.

Practical Installation Notes

  • Remove dirt and old grease from wheel bores before fitting for a firm seat.
  • Evenly tighten retaining screws to prevent axle play and wobble.
  • Confirm fit with any aftermarket wheel adapters to avoid clearance issues.

Do these hubs work with lifted TRX-4 builds?

They suit standard TRX-4 hex interfaces, but lifted or heavily modified suspension may require checking axle clearances and drive geometry first.

Will they affect motor load or speed?

Added wheel mass changes rotational inertia slightly; you may notice a minor change in acceleration feel, but driveline stress remains similar under normal use.

How often should I check these hubs?

Inspect after hard runs or rock impacts and re-torque fasteners as part of routine maintenance to ensure continued safe operation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved