TRAXXAS TRX-4 Machined Front C-Hubs Upgrade JR-TRX411-BK by Jazrider  [JR-TRX411-BK]

Machined front C-hubs engineered for TRX-4

This set of front C-hubs is manufactured from machined aluminum for use on the Traxxas TRX-4 chassis and is listed under JR-TRX411-BK. The part provides a metal mounting surface intended to replace the original plastic hubs to improve stability where steering precision matters.

Installers should treat the parts as direct-fit replacements for TRX-4 mounting points and inspect fit against existing knuckles and linkages. Because the hubs are metal, verify screw torque values and check that steering links and hexes clear through full travel. Use standard RC fastening practice to protect threads and mating hardware.

In terms of setup, aluminium hubs typically reduce flex at the hub interface, improving repeatability in steering geometry during technical moves. Expect possible changes in toe and steering feedback; re-check wheel alignment and steering endplay after installation and adjust trims or link geometry accordingly.