Traxxas TRX-4 Scaler Polyurethane Skid Plates TRX4ZSP16 by GPM  [TRX4ZSP16]

This upgrade pack supplies front and rear skid protection sized for scaler trail use on the Traxxas TRX-4 chassis. Components are cast in wear-resistant polyurethane to withstand rock contact and trail abrasion while keeping a scale-friendly profile that matches TRX-4 lines.

Included components from the original source are listed for clarity: front skid plate - 2 pcs, rear skid plate support - 2 pcs, rear skid plate - 2 pcs, M3.0x6 round head hex screw - 8 pcs. These items together form the 16 pcs kit referenced by the part code.

Installation guidance: the kit is intended as a direct fit for an original TRX-4 shell and is compatible with factory side steps; D90/D110 shells may need small DIY adjustments for perfect fit. Note that this kit will not fit with GPM #TRX4014 or TRX4014X side step assemblies, so confirm your hardware before installing.

Tuning note: use these pieces as scraping guards and styling parts for scaler builds; they influence slow-speed contact with obstacles rather than suspension behaviour. Keep all fasteners checked and verify clearance with any aftermarket bumpers during test fitting.

Compatible Models

• Traxxas TRX-4
• original TRX-4 shell
• D90/D110 shells