TRAXXAS TRX4 Aluminium Bumper Mount Kit TRX4331F by GPM  [TRX4331F]

Stiff front bumper mount for TRX4

This aluminium front bumper mount is an RC-scale hop-up crafted for TRAXXAS TRX4 TRAIL CRAWLER vehicles. The seven-piece set increases rigidity at the front bumper junction to better control chassis roll and movement on technical trails.

Install this aluminium part when you want a metal substitute for the factory plastic mounts to cut down on unwanted flex where the bumper meets the chassis. The installation uses the TRX4's existing bumper attachment points and the included fasteners are intended to provide a direct swap for many TRX4 configurations.

Intended solely as an RC upgrade, this component affects bumper position and chassis stability only; it is not suitable for full-size vehicles. After assembly, check clearance around the servo and suspension travel to ensure no binding or interference.

A practical front-end upgrade for TRX4 trail rigs where consistent bumper sit and reduced flex are required; confirm compatibility with your bumper design before final assembly.