TRAXXAS TRX4M FORD BRONCO 6061-T6 Adjustable Tie Rod Set TRX4M160 by GPM  [TRX4M160]

Adjustable aluminium tie rods for fine steering setup

This RC-scale tie rod kit is tailored for maintenance and tuning on the TRAXXAS TRX4M FORD BRONCO chassis. The rods are machined from aluminium 6061-T6 and use nylon ball ends to balance durability with a low mass. The set supports both upper and lower positions on the front and rear to improve steering consistency during track tweaks.

Adjustments are carried out by placing a small tool in the positioning hole and rotating the rod ends; the opposite thread directions allow precise length changes so you can correct toe and steering centring on 1/18 TRX4M vehicles.

As a replacement and upgrade item, these rods are useful for restoring link lengths after service and for small steering geometry changes on the specified TRX4M model.