Traxxas TRX-4M Front C-Hubs — Brass Caster Blocks JR-TRX4M02-BK by Jazrider  [JR-TRX4M02-BK]

Traxxas 1/18 TRX4M Bronco/TRX-4M Defender Brass Front Caster Blocks (C-Hubs) Set (Black)
Price:
NZD$16.28
Brand:
JAZRIDER
Model:
JR-TRX4M02-BK
Condition:
Brand New
Available in shop
Write a review

Upgraded Brass C-Hubs for TRX-4M Chassis

This JR-TRX4M02-BK kit provides brass front caster blocks (C-hubs) engineered for 1/18 scale Traxxas TRX-4M models. Supplied as direct-replacement components, they fit the TRX4M Bronco and TRX-4M Defender and carry a black finish.

Functionally the C-hubs set the caster geometry for the front wheels and interface with steering knuckles and hub carriers on the TRX-4M front axle. The heavier brass changes the system mass and yields a different wear profile compared to standard plastic items, influencing steering feel and front-end comportment on technical trails.

Installation guidance: confirm fit against the OEM C-hubs, inspect servo and steering link clearances, and ensure screw alignment matches the TRX-4M mounting pattern before final torque. The product is intended as an RC spare for hobby use only.

Compatibility: Traxxas 1/18 TRX4M Bronco, TRX-4M Defender.

How do I confirm these will fit my TRX-4M?

Measure your current C-hub mounting hole spacing and compare to the TRX-4M pattern; these are made to match TRX4M front mounting points for Bronco and Defender models.

Will brass change ride behavior?

Yes. Brass adds weight at the front axle which alters handling and can provide a more planted feel at low speeds compared to plastic hubs.

Any special fit considerations?

Check for servo and link clearance and ensure fastener alignment is correct for the TRX-4M mounting pattern before final assembly.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved