TRAXXAS TRX6 Front Center Rear CVD Shaft Set Aluminium/Steel - TRX6037SA by GPM  [TRX6037SA]

Aluminium 6061-T6 plus steel CVD shafts tuned for TRX6 use

This 21pcs drive shaft set is an aftermarket replacement and upgrade kit made for the TRAXXAS TRX6 MERCEDES-BENZ 88096-4 scale crawler, listed under model TRX6037SA. The design blends 6061-T6 aluminium elements with hardened steel to deliver a compromise between lighter rotating parts and strength in high-load areas across the front, center and rear assemblies.

These parts carry torque from the gearbox and motor to each axle output. The mixed construction helps maintain stiffness where necessary while keeping mass low enough for controlled low-speed crawling and smoother driveline response.

Use this set to refresh worn CVD joints or to alter drivetrain characteristics for heavier payloads or rough terrain. The 21pcs kit ships complete with the small stainless pins and silicone rings needed to fit the shafts to the indicated TRX6 configurations.

For RC hobbyists looking to improve drivetrain durability without swapping motors or gearboxes, the TRX6037SA kit replaces the key wear-prone CVDs across the TRX6 front, center and rear driveline with a mixed-material upgrade.