TRAXXAS TRX6 Wheel Offset Adapter Set 12mm Aluminium - TRX6010/12MM by GPM  [TRX6010/12MM]

12mm aluminium hex adapters for TRX6

This aluminium hex adapter kit is designed for TRAXXAS TRX6 MERCEDES-BENZ use and lets you alter wheel offset to tighten the gap between rim and hub. Machined from 6061 T6 aluminium, the adapters add 12mm hex thickness to move the wheel flange outward without changing axle cups or wheel hubs.

Installation is aimed at hobbyists comfortable with wheel and drive assemblies: remove the OEM hex, slide the adapter onto the hub, fit supplied shims where needed, then secure with the stainless fasteners provided. The parts are intended for the vehicle's front CVD and rear drive shaft and provide a simple tuning route to tweak handling by changing track width.

Because these are aftermarket parts, always check for tyre and suspension clearance before running. Use correct torque values on stainless screws to avoid deforming the adapter, and recheck wheel balance after significant offset changes.