This rear axle case protection plate is a scale-correct replacement designed to protect the centre section of the Unlimited Desert Racer chassis. Constructed from 1mm 304 stainless steel, the plate resists abrasion and helps keep the rear axle case underside steady during high-speed runs.
The supplied hardware supports a simple direct swap into the factory points: one protection plate, two round head screws (3x12) and two POM collars are included to isolate the plate from the axle case and prevent metal-on-metal contact.
Installation is quick and reversible: remove the original fasteners, place the POM collars between plate and axle case, then tighten the supplied screws. The metal finish creates a tidy underside without affecting the vehicle's handling.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved