TRAXXAS X-Maxx Aftermarket Aluminium Battery Tray TXM0126 by GPM  [TXM0126]

Aftermarket aluminium tray engineered for X-Maxx

This aluminium battery holder serves as a direct replacement hop-up for secure installation of 1/8 scale X-Maxx battery packs. The part emphasises solid retention and plate stiffness to hold larger 6S cells steady during rough terrain and setup shifts.

Installation follows the usual X-Maxx service steps: remove the stock tray fasteners, line the aluminium holder up with the chassis mounting points, and secure it using the original hardware or matching hex screws. The tray helps limit pack movement and promotes consistent contact for battery leads while still permitting routine battery swaps and safe balance charging access.

Functionally this upgrade concentrates on mechanical stability rather than electrical changes. It offers repeatable pack placement for mass distribution tuning and reduces connector stress after heavy jumps. Inspect mounting screws and check thread security after demanding running sessions.

Opt for this aluminium holder when you need a stiff replacement tray to keep 6S packs secure during rough use; expect easy swap-in fitment on X-Maxx chassis and follow recommended fastener checks.