TRAXXAS X-Maxx Aluminium Wheel Hex +1mm Fitment Claw TXM006/+1 by GPM  [TXM006/+1]

Wheel fitment claw for X-Maxx

This pair of aluminium wheel hex claws is produced for TRAXXAS 1/8 X-Maxx use and provides a +1mm offset to adjust wheel engagement. They are intended as direct replacement hexes that work with standard X-Maxx hub hardware while concentrating the upgrade on wheel sit and clamp security.

The slight offset is handy to clear tyre rub, seat aftermarket wheels more reliably, or make small track width adjustments for balance. Aluminium construction favours dimensional accuracy and wear resistance compared to plastic hexes, helping to maintain consistent wheel mounting under stress.

Fitting follows normal wheel service steps: remove the wheel and current hex, press the aluminium claw on to the hub, check it sits flush, then refit and secure the wheel per original suggestions. Perform a short run to confirm no rubbing and that retention is secure.

For hobbyists tuning TRAXXAS X-Maxx rigs, the +1mm aluminium hex claw provides a straightforward way to refine wheel fit and boost longevity without replacing hub components.