Traxxas X-MAXX Heavy Duty #45 Dogbone 3pc TXM1160S/1 by GPM  [TXM1160S/1]

Reinforced #45 Dogbone for Traxxas X-MAXX

This is an aftermarket replacement dogbone set for TRAXXAS X-MAXX chassis, identified as TXM1160S/1. Components are manufactured from steel #45 to provide a more robust driveshaft option compared with thinner stock pieces.

Key measurements noted: the shaft diameter increases through the section from 5.5mm to 7mm to resist bending under load, while the dogbone pins are given as 3.5mm diameter. The package lists 1 pcs 3.5-thread steel collar and 1 pcs 3.0x20 steel pin included with the three dogbones.

Practical notes: these upgraded steel dogbones are aimed at rough off-road use where a thicker shaft cuts flex and improves drivetrain stability. Always check wheel hub clearances on your X-MAXX ahead of fitting, ensure the 3.5mm pins seat correctly, and inspect retention fasteners after initial runs.