TRAXXAS X-MAXX Rear Wheel Hex Claw +3mm Brake Disk Upgrade TXM006R/DISK by GPM  [TXM006R/DISK]

Alloy rear wheel hex claw for tougher mounting

This alloy rear wheel hex claw featuring a machined brake-disk surface is made as an aftermarket upgrade for TRAXXAS X-MAXX users who want a more rigid wheel seat. The design sets a fixed +3mm offset to alter wheel stance and provides a clean, flat locating surface to reduce eccentricity under load.

Compared with stock plastic hexes, the alloy body limits flex where the wheel sits on the hex, helping maintain consistent tyre position during tyre swaps and higher-power runs. The brake-disk face is intended for mounting location and does not modify the vehicle's existing brake components.

Installation notes: fits into the X-MAXX rear hub location and retains using the same method as factory hexes. Fit using the correct fasteners and torque values to protect wheel studs, and check wheel runout after installation. Regularly inspect mating surfaces and thread interfaces on this machined metal item, and apply thread locker where recommended by drivetrain guidance.

For pilots adjusting rear behaviour on X-MAXX vehicles, this alloy hex claw provides a repeatable wheel mount and a modest +3mm stance change to dial in stability without hub modification.