TRAXXAS X-Maxx Steel Motor Gear 14T TXM014TS for gearing upgrades by GPM  [TXM014TS]

TRAXXAS 1/8 X-Maxx Steel Motor Gear (14T) - 1pc - GPM TXM014TS
Price:
NZD$18.37
Brand:
GPM
Model:
TXM014TS
GTIN:
4894538189667
Condition:
Brand New
Write a review

14-tooth steel pinion for X-Maxx setups

This 14T steel motor gear is designed for TRAXXAS 1/8 X-Maxx platforms and sold under the part code TXM014TS. Supplied as one piece, it is intended to replace the motor-side pinion to tune gear ratios.

Installation tips: verify motor shaft diameter and how the pinion is secured on your motor before fitting. Slide the gear into place, set the tooth mesh to the spur gear, and use the motor's original fastener or clamp to lock the pinion. Recheck mesh after a short run to confirm proper seating.

Performance notes: installing a 14T pinion shifts the balance toward higher top speed with lower initial acceleration versus larger pinions. Use this size when you want a top-end bias but keep an eye on motor and ESC temperatures during the first tests.

Construction and care: the steel construction gives improved wear resistance over brass options; treat it as a consumable item in the drivetrain and inspect the teeth periodically, especially after rough bashing or off-road sessions.

This item is compatible with

  • TRAXXAS XMAXX

Do I need a shim or spacer for fitment?

Some motors require a spacer or shim to achieve correct mesh; check your motor plate and shaft position and use shims if the mesh is too tight or loose.

How often should I inspect the pinion?

Inspect the pinion after heavy sessions or if you notice increased drivetrain noise; look for chipped teeth or unusual wear patterns and replace when needed.

Will 14T affect battery runtime?

Changing gear ratio can alter motor load and therefore runtime; a higher top-speed setup can draw more current at high speed, so monitor packs and temps on the first runs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved