TRAXXAX Slash 4X4 Front Knuckle Arm SLA021 by GPM  [SLA021]

Alloy replacement knuckle for stable steering

This pair of alloy front knuckles is designed as a direct replacement to reduce play and improve steering consistency on TRAXXAX Slash 4X4 machines. They fit in the stock locations and act as the primary steering link, keeping original geometry while limiting unwanted movement.

Installation advice: these knuckles fit into the existing front steering assembly without relocating servo linkages. Because they are made to tight tolerances, double check bolt locations and steering link alignment when installing so the steering rotates freely through full travel.

Setup notes: swapping to alloy knuckles gives a firmer pivot under lateral loads and helps maintain consistent toe and ackermann settings, which is handy when refining handling for both race and rough terrain driving.

Use these alloy knuckles where you want reduced steering slop and a firmer front feel, and always confirm alignment and travel after fitting.