TRF 416 Steering Knuckle Arm 416-18/LB by 3Racing  [416-18/LB]

Tamiya TRF 416 Aluminium Knuckle Arm - 3RACING 416-18/LB
Price:
NZD$21.42
Brand:
3Racing
Model:
416-18/LB
Condition:
Brand New
Write a review

Steering knuckle upgrade for TRF 416

Built as an aftermarket replacement, this aluminium knuckle from 3Racing fits the TAMIYA TRF 416 and is sold under model 416-18/LB. It replaces the stock knuckle with a metal component while preserving mounting points and ride geometry for straightforward swap-in installation.

From a setup perspective the knuckle provides a firm hub mounting surface and helps maintain suspension geometry while you experiment with camber, toe and damper settings. Installed on a TRF 416, it keeps steering inputs predictable so you can evaluate changes to handling without unintended geometry shifts.

Installation notes: fits using the TRF 416's existing brackets and screws. Follow your chassis guidance for torque and assembly sequence, and inspect linkages and wheel hex engagement after installation to confirm correct positioning.

Does this fit the stock TRF 416 knuckle mounts?

Yes. The part is made to match the stock mounting points on the TRF 416 for a clean direct fit.

Should I expect different tyre wear?

Tyre wear is mostly influenced by setup and driving style; the aluminium knuckle adds stiffness which can change loading on the tyre, so recheck camber and toe after fitting.

Recommended checks after fitting?

Confirm steering travel and hub concentricity, tighten fasteners to spec, and run a few short laps to judge steering consistency before final setup changes.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved