TRF104 Roll Spring Mount Graphite 2.0 compatible with Tamiya - Factory Pro O-TCPF08  [FP-O-TCPF08]

Price:
NZD$15.08
Brand:
Factory Pro
Model:
FP-O-TCPF08
Condition:
Brand New
Write a review

TRF104 suspension mount description

The Factory Pro O-TCPF08 roll spring mount is a Graphite 2.0 component built for tuning the Tamiya TRF104 chassis at 1/10 scale. It functions as the anchor for roll springs and is used to tweak roll characteristics and the effective roll centre during setup work.

Installation replaces the original TRF104 mount directly and requires standard hobby tools plus the original fasteners. When fitting, make sure the suspension geometry lines up and springs sit cleanly in their seats, since minor offsets can change on-track behaviour.

Use incremental changes when testing this mount: swap one side or one mount at a time, record handling differences, and combine with spring and damper tweaks to find the right setup. This description is for RC model use only and does not apply to full-size vehicles.

Can I use this on other touring car frames?

The part is aimed at the TRF104 chassis. To fit other frames you will need to confirm mount spacing and screw locations match before proceeding.

Are special fasteners required?

No special bolts are normally needed; reuse the stock hardware where compatible. Keep thread inserts and torque settings in mind to prevent damage.

What tuning strategy works best with this mount?

Adjust one variable at a time and test in consistent conditions. Combine mount changes with spring rate and damper tuning to dial in corner balance and mid-corner grip.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved