TRF421 Graphite Rear Body Post Base - Tamiya O-TCP007  [FP-O-TCP007]

Price:
NZD$18.00
Brand:
Factory Pro
Model:
FP-O-TCP007
Condition:
Brand New
Write a review

Graphite Rear Post Plate for TRF421

This graphite rear body post plate is an RC-scale replacement tailored for the Tamiya TRF421 chassis and sold as Factory Pro model O-TCP007. It acts as the contact surface for rear body posts and anchors the body to the TRF421 chassis mounting points.

The plate helps cut down on slack and movement between body and chassis during hard cornering, keeping body height and lateral alignment more consistent. That consistency makes it easier to fine tune handling and maintain predictable aerodynamic behaviour on different tracks.

Installation is simple for anyone used to TRF421 body mounts: remove the stock piece, fit this plate to the original post positions, then check clearances and alignment before fully tightening. This component is for model use only.

Does O-TCP007 work with Tamiya TRF421 bodies?

Yes, the plate is designed for the TRF421 post layout and will replace the standard rear body post mount in most setups.

Will this change my car balance significantly?

It is intended to stabilise the rear body rather than alter balance dramatically; improved repeatability of body height can make tuning more predictable.

How should I check clearance after fitting?

With the body mounted, roll the car and inspect wheel and body clearance through suspension travel, and ensure posts are not binding against the body during movement.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved