Trumpeter 09943 20cm Brass Pipes Precision Set  [TP09943]

Trumpeter 09943 - 20CM Brass Pipe Set 2 - 8pcs
Price:
NZD$7.41
Brand:
Trumpeter
Model:
TP09943
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Trumpeter 09943 Brass Pipes for Precision Modelling

The Trumpeter 09943 20cm brass tubing pack is aimed at builders who want clean metalwork on their RC projects. These tubes are handy for adding scale-accurate features, strengthening assemblies or fabricating bespoke fittings.

Why Model Builders Choose Brass

Brass machines cleanly and accepts solder, adhesives and paint reliably, making it a preferred choice for hobbyists. It balances rigidity and malleability so you can form small bends or cut precise sections for tight installations.

Common Uses and Advantages

  • Scale Detailing: Use for realistic piping, mock exhausts and fine trim that lift model authenticity.
  • Chassis Reinforcement: Add discreet support to vulnerable points on frames and mounts.
  • Wide Compatibility: Works across car, boat and aircraft modelling with straightforward modification.
Yes, brass is solderable with appropriate flux and low temperature solder. Clean the surfaces and practise on offcuts to get reliable joints without damaging thin walls.
They take primer and paint well after a light scuff and degrease. For authentic weathering, use washes and dry-brushing rather than aggressive abrasives.
Use cyanoacrylate with a primer for small joins, or epoxy for stronger bonds. Mechanical fixing with small screws or pins is also effective for load-bearing points.
Small bends are possible with careful heating and support, but for tight curvature use thinner wall sections or pre-form jigs to avoid kinks.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved