TRX4 25T Aluminium Servo Horn 4-Hole Adjustable for Trail Crawling TRX4025TL by GPM  [TRX4025TL]

25T alloy servo horn for scale crawling

This aluminium servo horn is an RC-scale replacement intended for TRAXXAS TRX4 Trail Crawler steering assemblies. With a 25T spline and straight-arm layout it increases stiffness versus stock plastic arms, which helps under repeated steering loads and low-speed torque conditions.

Mechanical function: it transmits servo output to the tie rod and the four selectable holes let you tweak steering ratio and tie-rod length in fine increments without needing alternative arms. That adjustability is useful when dialing in steering behaviour and centring on crawlers.

Installation advice: line up the spline teeth carefully, secure the horn using the supplied fasteners and confirm neutral before fully tightening. For metal-to-metal screw locations consider a small amount of thread-lock and recheck full-lock travel after fitting.

• Sold as 4 pcs set.
• Includes: Servo Arm - 1 pcs, Stainless Steel Round Head Screw 3x14 - 1 pcs, Stainless Steel Flat Head Screw 3x8 - 1 pcs, Stainless Steel Cap Head Screw 2.5x6 - 1 pcs.