TRX-4 Aluminum Motor Mount Upgrade for Traxxas - JR-TRX402-GU by Jazrider  [JR-TRX402-GU]

Traxxas TRX-4 Aluminum Motor Mount Plate (Gun Metal)
Price:
NZD$9.90
Brand:
JAZRIDER
Model:
JR-TRX402-GU
Condition:
Brand New
Write a review

Precision fit motor mount for TRX-4

This aluminium motor mount plate is a scale RC replacement manufactured for Traxxas TRX-4 applications and supplied with a gun metal finish. It creates a rigid junction between the motor and drivetrain mounts to maintain accurate shaft alignment during demanding trail use.

Designed as an upgrade or spare for TRX-4 scale and rock crawlers, the plate helps limit movement at the motor mounting point and keeps pinion-to-spur engagement consistent. The gun metal surface hides light wear from handling while offering a subtle scale appearance.

Installation notes: the component is intended to reuse the chassis' existing bolt locations and fasteners for a straightforward swap. Always confirm motor shaft height and gearbox clearances before final assembly to ensure correct gear interaction.

Do I need extra hardware to fit this plate?

No special hardware is normally required; the plate is designed to use your TRX-4's existing mounting points. Have your stock screws and washers ready and verify thread engagement during refit.

Any tips for aligning motor and gearbox?

Position the motor loosely, check pinion-to-spur mesh, then tighten progressively. If necessary adjust motor height or use thin shims to achieve even contact without binding.

Is the gun metal finish durable?

The gun metal coating offers resistance to light abrasion and maintains a subdued look after normal trail handling, but heavy impact or dragging may mark the surface.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved