TRX-4 Defender Fender Vents TRX4ZSP1 by GPM  [TRX4ZSP1]

Detail vent set for TRX-4 shells

This 36 piece vent kit uses 3D printed parts to add authentic venting detail to TRX-4 scale bodies. The components improve visual realism on scale shells while remaining non-intrusive to drive or electrical systems.

The pack includes hardware so you can install vents permanently with screws or temporarily with tape. Hardware supplied: M1.2x5 philips screws - 16 pcs, M1.2 lock nuts - 16 pcs, double sided tape - 2 pcs. Use the tape on thin polycarbonate shells or the screws where the body has fixing points.

Fitting is simple: place the vents over the cutouts or arch area and secure with the supplied M1.2 screws and lock nuts, or stick them on with the double sided tape for test fitting. These pieces are intended purely for appearance and will not interact with servo, ESC, motor, or suspension parts.