TRX-4 Defender Front Fender Vent Set ZSP043 by GPM  [ZSP043]

TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043
Price:
NZD$25.54
Brand:
GPM
Model:
ZSP043
GTIN:
4894538320343
Condition:
Brand New
Write a review
alt="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043" title="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043"
alt="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043" title="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043"
alt="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043" title="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043"
alt="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043" title="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043"
alt="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043" title="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043"
alt="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043" title="TRAXXAS TRX4 TRAIL CRAWLER Metal Fender Vent (Style B) - 16pc set - GPM ZSP043"

Scale front fender vents for trail rigs

This 16-piece metal vent set is designed for scale trail crawlers and fits the front fender areas on compatible shells. Crafted from stainless steel with precision bends, the vents recreate realistic Land Rover trim at miniature scale while remaining an aftermarket body accessory.

The package contains vents plus mounting screws for decorative installation; these parts are intended to enhance realism and do not change drivetrain or suspension behavior. Verify fitment on your particular shell before final assembly, and use the supplied screws that match the vents in this kit.

Fitting tips: line up each vent on the front fender, fasten using the included screws through pre-existing or hand-prepared holes, and tighten gradually to prevent deformation. Minor trimming or hole enlargement may be needed depending on shell thickness and aftermarket variations.

Compatible Models

  • TRAXXAS TRX-4 DEFENDER
  • RC4WD D90 / D110

How are the vents finished?

The vents are precision-bent stainless steel with a clean industrial finish intended for scale appearance and moderate corrosion resistance.

Are these vents compatible with aftermarket shells?

They are listed for TRX-4 Defender and RC4WD D90/D110 bodies; due to shell differences, test-fit and adjust mounting holes where required.

Can I paint the vents to match my body?

Yes, you can mask and paint stainless steel vents, but prepare the surface with a suitable primer for adhesion before finishing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved