TRX4 Front Drive Dogbones #45 Steel 4pc Kit TRX44571/SH by GPM  [TRX44571/SH]

Front drive dogbones for TRX4 CVD use

This 4 piece dogbone set is designed specifically for the TRAXXAS TRX4 Trail Crawler front CVD and is manufactured from hardened #45 steel for resistance to wear under load. The set is supplied to match the stock shape so it fits without alteration.

Functionally the dogbones carry drive torque from the front CVD into the axle shafts, linking drivetrain output to the hubs. The package includes two 11.8mm stainless pins to hold each dogbone in place during driving.

Key dimensions are provided to aid fitting checks: long leg 71mm, short leg 45mm. Confirm these against your steering and suspension travel to avoid interference.

Installation guidance: intended as a direct front-end replacement on TRX4 layouts that accept the same dogbone geometry. Remove the factory dogbones and fit the supplied parts with the retention pins as standard procedure.