TRAXXAS TRX-4 Scale Bumper D-Rings, Aluminum, Front and Rear - JR-TRX403-BK by Jazrider  [JR-TRX403-BK]

Scale recovery D-rings for TRX-4 bumpers

The JR-TRX403-BK kit supplies RC-scale aluminum D-rings designed specifically for the front and rear bumpers of TRAXXAS TRX-4 rigs. The pieces give precise tie-down areas suitable for scale recovery gear and exterior detailing while preserving bumper geometry.

Fitting is straightforward on compatible bumpers: place the D-ring over the bumper's D-ring mounting holes and fasten with the bumper's existing bolts or correct-length screws. Typical hobby drivers will handle the job; perform a quick alignment check so the rings sit level with the bumper surface.

Built with trail use in mind, these D-rings function as realistic anchor points and styling upgrades. They accept shackles, straps, or small tow lines during crawl sessions and photos, and their light construction keeps effects on suspension and drivetrain negligible.