TT-02 Compatible Aluminum Front Knuckle Arms JR-TT201-BK for TAMIYA by Jazrider  [JR-TT201-BK]

Tamiya TT-02 Aluminum Front Knuckle Arms (Black)
Price:
NZD$19.45
Brand:
JAZRIDER
Model:
JR-TT201-BK
Condition:
Brand New
Write a review

Light alloy knuckle arm option for the TT-02

The JAZRIDER JR-TT201-BK is an aluminum front knuckle arm developed for use on the TAMIYA TT-02 chassis. It is supplied as an aftermarket upgrade to offer reduced flex at the steering pivot versus standard plastic knuckles, aiding more repeatable steering geometry when the car is under load.

Installation mirrors the original TT-02 suspension arrangement. Replacement normally requires wheel removal, disconnecting the steering linkage, and swapping the knuckle arm on the hub carrier and hinge pin. Inspect hinge pins and fasteners for wear during the swap and confirm steering travel and toe settings afterwards.

When tuning, these aluminum arms help stabilise steering feedback during camber, toe, or roll center adjustments. They are aimed at hobby drivers and club racers who prioritise consistent steering behaviour.

How does the aluminum hold up compared to standard parts?

Aluminum knuckles reduce component flex and resist deformation under load, offering improved repeatability over standard plastic pieces in most hobby driving scenarios.

Are these knuckles prone to bending or cracking?

Aluminum resists flex but can bend or crack under severe impact; check for damage after crashes and replace if structural integrity is compromised.

Will aluminum change wear on other suspension parts?

Stiffer knuckles can transfer different loads to hinge pins and bearings; inspect mating parts and fasteners for increased wear during setup checks.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved