TT02/TT02B Replacement Propeller Shaft Gear for TAMIYA TT2100/G2 by GPM  [TT2100/G2]

Tamiya TT02B Steel Propeller Shaft Gear - 1pc (For TT02 / TT02B) - GPM TT2100/G2
Price:
NZD$13.24
Brand:
GPM
Model:
TT2100/G2
GTIN:
4894538216189
Condition:
Brand New
Write a review

Replacement Prop Shaft Gear for TT02/TT02B

This steel propeller shaft gear is made for use on TAMIYA TT02 and TT02B models and is identified by part number TT2100/G2. It is intended as an RC-scale replacement to restore centre driveline engagement without altering motor or gearbox mounting.

Constructed from steel to improve wear resistance over softer factory parts, the gear is suited to regular running, club-level practice, and tuning where dependable gear meshing matters.

Fitment guidance: remove the drive shaft per your service instructions, inspect surrounding spur, pinion and bearing condition, install the gear and confirm correct mesh and backlash before running. The part is supplied as one piece for chassis repairs and upgrades.

Compatible Models

  • TT02
  • TT02B

Is this suitable for on-road and light off-road use?

Yes. The steel gear is robust for normal on-road and light off-road conditions typical for TT02-series cars, provided other driveline components are in good condition.

Will this affect gear ratios or motor fitment?

No. This is a like-for-like replacement that maintains the original geometry and will not change gear ratios or motor alignment when installed correctly.

How should I inspect the gearbox after installation?

After fitting, rotate the drivetrain by hand to feel for rough spots, check for even backlash across the mesh, and run a short low-speed test to confirm smooth operation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved