TY1 HS7728TO 38mm Spinner (D3.0mm Shaft) Translucent Orange  [HS7728TO]

TY1 38MM ELECTRIC SPINNER FOR D3.0MM MOTOR SHAFT (TRANS. ORANGE) #HS7728
Price:
NZD$12.01
Brand:
TY1
Model:
HS7728TO
Condition:
Brand New
Write a review

Spinner tailored to a D3.0mm shaft

This 38mm spinner was created as an RC finishing piece to fit motors with a D3.0mm shaft, giving a neat nose contour for electric propeller installations. The translucent orange surface improves visibility for pre-flight inspection and identification on the model.

Check shaft diameter carefully: the spinner is centred on the D3.0mm dimension, so confirm any shaft shoulders or flats before mounting. It is intended as a cosmetic and trimming accessory and is useful when balancing props and refining nose weight for flight behavior.

Mounting advice: ensure the spinner slides onto the D3.0mm shaft without interference and that it clears nearby cowlings or mounts. Use standard spinner mounting steps for your airframe and re-check dynamic balance after adding propellers or adapters.

How do I confirm the spinner will fit my motor?

Measure the shaft diameter and inspect for any steps or flats; the spinner expects a straight D3.0mm section. Use an appropriate adapter if your shaft profile differs.

Will the colour affect visibility during setup?

The translucent orange enhances contrast for pre-flight checks and does not alter mechanical balance, though you should always balance the spinner and prop together.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved