Universal 2-Pin Drift Bone for Yokomo DP and MRTC Deep-Rim Shafts - Yokomo D-041A  [D-041A]

Drift-Grade Universal Bone with 2mm Pin

This RC-scale universal bone is made for both front and rear fitment on deep-rim universal shafts where a reinforced 2mm joint pin is required. It is aimed at drift setups and lists compatibility with a wide selection of Yokomo DP and MRTC drift chassis shown below. The item functions as a drivetrain coupling component for scale model cars and should be treated as a hobby part.

Only use the specified 2mm reinforced joint pins for installation. Confirm pin seating, allow adequate rotation clearance, and align splines accurately before final clamp down. During routine service, check the pins for wear and keep the mating shaft faces clean to reduce the chance of binding in the deep-rim system.

Setup impact: installing this bone preserves coupling geometry through large articulation, which aids a consistent drivetrain feel and reduces play when fitted correctly in the compatible chassis.