This 4.5mm aluminium rod end adapter is offered as a drop-in option for front lower arm linkages, preserving the 17mm overall length commonly used on factory turnbuckle setups to keep stock geometry intact.
Aluminium gives a lighter option compared with steel rod ends, which can influence steering response during transient inputs when included as part of a front-end tuning setup. The part is supplied as a twin pack so both sides can be replaced at service intervals.
Installation follows normal turnbuckle practices: remove the old rod ends, verify thread form and engagement, fit the aluminium adapter, then confirm correct endplay and alignment before driving. Double-check seating after the first run.
Compatibility is documented by the maker and includes DP-RS13SP plus various DP, SDR and DPR chassis lines such as DP-YD2 and DP-GR86 variants; always check the official parts list or your chassis manual for exact matches prior to purchase.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved