Upgrade for HPI Bullet Front Chassis Brace, Orange Alloy BUL-18004-OR by JAZRIDER  [BUL-18004-OR]

Alloy brace for the Bullet front end

The BUL-18004-OR is an RC-scale alloy front chassis brace that replaces the stock front brace on HPI Bullet machines. It is made to reduce flex at the junction of the front suspension and chassis so drivers can dial in sharper steering feel and steadier balance without altering core suspension geometry.

Compatibility is aimed at HPI Bullet 3.0 MT and ST nitro models, so verify your Bullet chassis variant before purchase. The orange anodised finish gives a durable, low-profile brace that mates to the factory mounting points around the front bulkhead and shock tower areas.

Installation is aimed at hobbyists comfortable with front-end teardown: remove the factory brace, position the alloy brace over the factory holes, and fasten using the original screws for a direct fit. There should be no repositioning of servo, ESC, or motor gear as the part changes chassis stiffness rather than drivetrain layout.

From a setup standpoint, consider this as a front stiffness option: fit it if you need sharper turn-in or reduced flex while braking and accelerating. It works alongside common Bullet tuning moves such as anti-roll bar tweaks or revised shock valving to refine on-track balance.