Upgrade for HPI Savage X Drivetrain Cup Joint 8x14x19mm HPI-86277 by Jazrider  [HPI-86277]

Price:
NZD$0.00
Brand:
JAZRIDER
Model:
HPI-86277
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Reinforced cup joint designed for Savage X

The HPI-86277 cup joint is supplied as a pair and tailored to HPI Savage X drivetrains, finished in silver and sized 8x14x19mm. Confirm this geometry against your current components before ordering to ensure a direct replacement without modification.

Installation guidance: replace joints one side at a time, inspect driveshaft yokes and drivepins while the shaft is disassembled, press the new joint into the yoke with proper seating, then reassemble using the original hardware and recommended tightening sequence. Typical RC hand tools are sufficient for the swap.

Service notes: these heavy duty joints are a wear item that stabilizes the driveline; check for looseness or scoring regularly, clean contact surfaces to prevent abrasive wear, and fit fresh joints in matched pairs when deterioration is found.

How much tougher are these compared to stock parts?

These are described as heavy duty designs intended to better resist normal wear under aggressive use, but actual lifespan depends on operating conditions and maintenance.

Should I replace both joints at once?

It is recommended to replace cup joints in pairs to maintain balanced wear and consistent driveline geometry.

What routine checks keep them lasting?

Periodically inspect for axial play, clear debris from the mating surfaces, and apply light lubrication where metal contacts metal to reduce abrasive wear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved