Upgrade Steering Arm for Axial SCX6 1/6 Jeeps - JR-SCX607-TI by Jazrider  [JR-SCX607-TI]

Axial 1/6 SCX6 Jeep 7075 Aluminum Steering Servo Arm (Titianum)
Price:
NZD$11.86
Brand:
JAZRIDER
Model:
JR-SCX607-TI
Condition:
Brand New
Available in shop
Write a review

Steering arm upgrade for Axial SCX6

Built for Axial SCX6 1/6 scale Jeep rigs, this steering servo arm carries the JR-SCX607-TI identifier. It replaces common plastic arms to provide a firmer mechanical link from the servo to steering linkages on scale trail vehicles.

Fitment is concentrated on Axial SCX6 Jeep JLU Wrangler 1/6 scale setups; always verify spline pattern and hole spacing on your servo prior to installation. The part is precision machined from 7075 aluminum, chosen for its durability in RC steering components.

Installation steps: remove the factory arm, confirm spline engagement, mount the new arm on the servo spline and secure with the original screw or compatible fastener. Once fitted, check full motion and steering geometry to confirm proper toe and clearance. This product is an aftermarket steering linkage upgrade for RC vehicles only.

How can I confirm spline compatibility before buying?

Measure the spline count and compare hole positions on your current servo arm to the replacement; if they match you will usually have a direct fit.

Will this change steering feel on trails?

Yes, swapping to a 7075 aluminum arm typically reduces flex and produces crisper steering feedback under load.

Do I need special tools to fit it?

Standard hand tools suffice for most installs; a small screwdriver and a wrench for tie-rod adjustments are usually all you need.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved