Serpent 600661 Aluminium Rear Uprights for Cobra 2.0 Race Use  [SER600661]

Serpent SER600661 Upright Left + Right 811 2.0 Aluminium
Price:
NZD$89.28
Brand:
Serpent
Model:
SER600661
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision aluminium uprights for the Cobra 2.0

The Serpent 600661 aluminium rear uprights are made with race-minded tolerances for the Cobra 2.0 buggy, combining low mass with a tough 7075 T6 alloy construction. They are intended to give consistent bearing alignment and stable rear end behaviour.

Solid fitment and corrosion resistance

These uprights are machined for a snug bearing fit that reduces movement under load. Threaded mounting bosses make swapping quick, and the grey anodised finish helps protect against chips and moisture from outdoor tracks.

Compatibility tips and upgrade path

Built to match the Serpent Cobra 2.0 geometry, the uprights drop into place with no cutting needed. For a complementary setup, consider the Upright L+R 811 2.0 (#600634) to keep suspension balance consistent.

Do these uprights need shims for bearings?

The uprights are machined for common bearing sizes and usually do not require extra shims. Verify bearing play after assembly and add thin shims only if needed.

Is 7075 T6 noticeably better than 6061 for this use?

7075 T6 offers higher tensile strength than 6061, which helps the uprights resist bending during hard landings and aggressive cornering. It is a common choice for performance parts.

Will the anodised finish affect bearing fit?

The anodised coating is thin and does not change bearing seating dimensions. If you are replacing bearings, clean mating surfaces before press fitting for best results.

Any setup changes after installing these uprights?

After fitting, check toe and camber and make small adjustments as needed. The stiffer uprights can alter rear feel slightly, so fine tuning is recommended.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved