VANQUISH H10 OPTIC Oversized Outer Bearing Rear Third Member H10013A for H10 OPTIC by GPM  [H10013A]

Rear third member with larger outer bearing

This aftermarket third member H10013A is CNC-machined from 7075-T6 alloy and intended to replace the factory rear axle third member on the compatible VANQUISH kit listed below. The outer race area has been resized to take a 5x14x5mm oversized bearing while other bearing seats retain factory dimensions.

Units are supplied pre-assembled to speed up installation. This kit supersedes part VPS08606 and is tailored to RC-scale fitment on the referenced H10 OPTIC chassis. Installation uses standard hobby tools and follows the original mounting pattern.

To maintain secure operation, use a medium-strength threadlocker on fasteners where vibration could loosen hardware. The upgrade focuses on outer bearing robustness and simplified serviceability for drivetrain maintenance.

As a direct-fit alloy swap for the VANQUISH H10 OPTIC kit, this third member H10013A provides an enlarged outer bearing seat for the specified 5x14x5mm bearings and arrives pre-assembled for fast installation.