Walkera HM-4#3B-Z-10 Precision Swashplate for 4#3B  [HM-4#3B-Z-10]

Walkera (HM-4#3B-Z-10) Swashplate
Price:
NZD$14.58
Brand:
Walkera
Model:
HM-4#3B-Z-10
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Walkera - 4#3B category
Write a review

Fine-Tuned Swashplate for Your 4#3B

The Walkera HM-4#3B-Z-10 Swashplate is crafted to restore accurate cyclic and pitch inputs on the 4#3B helicopter. It is suitable for pilots who want to maintain factory handling or tune their machine for tighter control.

Sharper Control and Long Service Life

Specifically matched to the Walkera 4#3B, this swashplate helps tighten response across the control system and resists wear from regular flying. It is a practical choice for both maintenance swaps and modest performance upgrades.

Compatibility Notes and Fitment

Compatible with the Walkera 4#3B family, the HM-4#3B-Z-10 installs with minimal setup changes. The swashplate aligns with standard servos and linkage layouts to reduce trimming time after installation.

Can I use this swashplate with upgraded servos?

Yes, it pairs well with higher torque servos, but check travel and end points so the swashplate sees correct throw and avoids binding.

How often should I inspect the swashplate?

Inspect it after every few flying sessions or after any hard landing; look for looseness or rough rotation to catch wear early.

Is any special grease required?

A light bearing grease on rotating surfaces helps longevity, but avoid heavy oils that attract dust and grit which can accelerate wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved