White Rod End Replacements for R/C - Yokomo YOKBM206W  [YOKBM206W]

Compact plastic rod ends for R/C steering

The Yokomo YOKBM206W rod end plastic parts serve as an RC-scale replacement for tie-rod and turnbuckle connections in steering and suspension linkages. These white plastic rod ends create a compact connection point where a ball end or turnbuckle meets the linkage and are intended for general tie-rod systems rather than a particular chassis.

Produced as straightforward service spares, the parts address wear and play that develops over time in steering linkages. Plastic rod ends sacrifice some hardness compared with metal but offer quieter operation and lower cost, making them popular where reduced binding and lower mass are desirable. Expect normal plastic traits: adequate wear life for hobby use and a degree of flex versus metal pieces.

Fitting is direct: remove the worn rod end from the turnbuckle or linkage, press the new part into place so the ball-seat seats correctly, and check that movement is free through the full travel. After installation, inspect for excessive play and verify steering centring. Since these fit general tie-rod and turnbuckle arrangements, confirm your thread sizes and ball-seat type on the vehicle before fitting.

From a tuning viewpoint, plastic rod ends alter steering compliance and feedback; changing to a firmer material or metal rod ends is a common approach to sharpen steering response. Alternatively, plastic ends can help damp small impacts and reduce shock transmitted to the servo in regular running.