Wishbone Insert Set for Medius X26 - Serpent 402180  [SER402180]

Medius X26 insert pack overview

This RC-scale accessory is supplied as a direct-fit wishbone insert pack for the Serpent Medius X26 platform. The package holds 12 X26 inserts intended to sit within the wishbone pocket to adjust local contact and fit between the arm and pivot, allowing suspension tuning without swapping major components.

Role in setup: installed inserts reduce slop at the pivot, alter small leverage points, and provide a straightforward way to adjust compliance during setup work. They suit 1/10 electric touring car suspension tasks where modest geometry or compliance tweaks are needed.

Fitting guide: remove the wishbone from the chassis, clear the pocket of debris or burrs, press the X26 insert into the cavity until it seats, then reassemble and inspect movement across the full travel. Confirm steering clearance and suspension travel before use. No specialist tooling is required beyond standard hobby tools; handle steel inserts with care.

Compatibility note: made specifically for use with the Serpent Medius X26 chassis family and intended to work with existing Medius X26 steel components where insert tuning is available.