WR02C Wheelie Bar Aluminium Launch Control WRC2333R by GPM  [WRC2333R]

Wheelie bar made for WR02C setups

This aluminium wheelie bar is an aftermarket component for the Tamiya Honda City Turbo WR02C, supplied as one set. It helps manage front lift during strong acceleration and provides a consistent anchor point for launch tuning on the WR02C chassis.

Fitting requires locating the bar to the WR02C rear mounting points and securing it using existing holes or the vehicle's rear bracket. Adjust the bar's height and fore-aft position to change leverage and alter how the car balances under throttle.

Treat this part as a tuning accessory rather than a structural brace: confirm there is adequate clearance to the motor, ESC and that suspension articulation is not impeded by the bar.

Fine-tune bar position in small increments and re-check full travel and drivetrain clearance after each change to dial in launch behaviour.